Uyen’s blue pear-shaped ring and contoured band on her hand, beside Michael’s gold band.

Uyen spotted the curve we missed in her wedding band

Uyen’s pear-shaped blue diamond ring was a discontinued design. Every wedding band she tried left a gap. We asked her to send a video from every side, along with a few measurements. Then we made a first digital model. Uyen saw what we’d missed.

First, we needed the height as well as the outline

The top view showed the pear and the small diamonds trailing down one side. The side measurement told us how much room a band would have underneath. We rebuilt her engagement ring digitally before drawing the band beside it.

Two photographs Uyen sent with a measuring tape, showing the face and side of her engagement ring.
Uyen measured the outline and the setting height so we could rebuild the ring digitally.

We’d drawn a curve. Her ring had a subtle V.

Look at the first model, then the revision. We went back to her video and sharpened the contour to follow that V. Uyen also wanted to wear the band under the rounded end of the pear, so we adjusted the curve again.

The first wedding-band model has a rounded contour. The revision follows the pear ring’s subtle V.
The softer first curve above and the revised V below. Follow the upper edge of the band in each model.

The finished fit

Mr. Lee hand-polished both 14K yellow-gold bands. Hers carries diamonds and Michael’s is a clean 3 mm band. Both have “MU” engraved inside. The photo they sent back shows the part we’d all been working toward: two rings meeting neatly on her hand.

The finished wedding band nested against Uyen’s pear diamond engagement ring in a ring box.
The finished rings from another angle, nestled together in the box.

Show us the ring your wedding band needs to fit


More of our couples

Every ring we make is for someone. Read the short notes our couples sent us after the question was asked.